chassis Corsair Carbide Quiet 600QPost Date: 2018-05-15 |
Post Reply
|
Author | |
carey
Newbie Joined: 15 May 2018 Online Status: Offline Posts: 5 |
Quote Reply
Topic: chassis Corsair Carbide Quiet 600Q Posted: 15 May 2018 at 9:53pm |
The "Slade" desktop model photos shows a mesh screen in front of the fans. Exactly how do I find and get to this screen to clean it?
|
|
bprat22
DS ELITE DigitalStorm East -- (Unofficially!) Joined: 08 Jun 2011 Online Status: Offline Posts: 20391 |
Quote Reply Posted: 16 May 2018 at 1:52am |
The front panel has 3 clips on the inside of each side. Push to remove, then the panel pulls off. The side covers are removed to get to the clips.
Hope this helps. |
|
carey
Newbie Joined: 15 May 2018 Online Status: Offline Posts: 5 |
Quote Reply Posted: 16 May 2018 at 4:27pm |
Easier said than done. There's 4 clips on each side. Three of them were near impossible to undo, one because cables were in the way, and two because there was barely enough room to squeeze a finger in between parts of the chassis. Additionally, the fit around the two drives in the externally accessible drive bays were so tight I had to pry it off. To get it to go back on I had to file down the plastic of the drives' face plates slightly. -- Thanks for the post, that at least let me know it should be possible.
|
|
bprat22
DS ELITE DigitalStorm East -- (Unofficially!) Joined: 08 Jun 2011 Online Status: Offline Posts: 20391 |
Quote Reply Posted: 17 May 2018 at 2:01am |
Thanks for the feedback. Might help others.
Never could figure out why Corsair would make their front panels so difficult to remove. It’s like that on a number of their products. |
|
Post Reply |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |